Instructions!  

1-   Make a dot where you want the hole to go in the lid. 


2-  If you are using the drill, make a starter hole with the screw driver first.  Pound the back of the lid with the screw driver and the hammer.  It doesn’t take much to make a hole.  Then, take the drill and hold the lid very, VERY tight.  It will try to spin on you if you don’t.  Remember, 3/8 drill bit.


3-  Put the nipple through the hole.  On both sides of the lid, add a washer, and then a coupling.  The nipple should be longer underneath the lid than on top of the lid.  You will want the nipple and coupling to be flush on top of the lid. 

 



4-  After that is attached, twist your strip of t-shirt and then thread it through the nipple.  It will expand a little after it is soaked with oil.


5-  Add oil to your jar to the desired amount. 


6-  Attach completed lid back onto the jar. 

7-  You will want to wait for the oil to soak all the way up the t-shirt before you light it, otherwise it will just burn it up. 
Warning: Candles are dangerous. Please take all safety precautions.
 
For more inspiration and ideas you can check out Ms Dawns site here:
Source: Msdawn
 
 

 
 

17 Comments

  1. Aida Alequin-Rosich Reply

    Shirley Velasco I believe this would be helpful. I’m going to try one.

Write A Comment


Important This site makes use of cookies which may contain tracking information about visitors. By continuing to browse this site you agree to our use of cookies.